At the next startup, you can test to see if Shockwave Player is working correctly using this link ( here).
Note: Keep in mind that this method is only confirmed to work with older Windows versions (Windows XP, Windows 7 and Windows 8.1).
The issue is also reported to occur when the user tries to install Shockwave again from the official download page. The Error 2753 error is typically encountered when the user tries to use Adobe Shockwave after it was incorrectly installed. To ensure the best possible results, start with the first method (if it’s applicable) and follow the rest of them in order until you stumble upon a fix that is effective in getting the issue resolved. The methods below were confirmed to work by users struggling with the same kind of error message. Below you have a collection of methods that will apply to various different scenarios that will trigger the Error 2753 the file is not marked for installation issue. If you’re looking for a fix that will allow you to circumvent this particular error, this article will provide you with a list of troubleshooting steps.
How to fix the Error 2753 the file is not marked for installation issue In this case, the solution is to delete the InstallShield folder and enable the Windows Installer service. The error message can also be caused by a corrupted InstallShield folder – This is typically reported to occur with Corel and Pinnacle Studio installations.In this case, the solution is to use the Shockwave uninstaller. Adobe Shockwave is incorrectly installed – This error might occur if the Showckwave installation was halted in the middle of the installation process.
Print and File sharing is not installed or enabled when installing MSDE 2000.A general error occurred during the installation.An older version of Install Shield Developer is being used.The setup was corrupted after installation and, therefore, fails with this error during un-installation.The Microsoft Windows Installer Service is not installed correctly.A file is locked and cannot be overwritten.An Install Script custom action is prototyped incorrectly.Short file name creation is disabled on the target machine.The following is a non-exhaustive list of known causes for this error: You notice the error message because the Windows Installer service uses the SYSTEM account to install software.